12
M600 / ZENIT 60 / ACTIVE X6 / ACTIVE ULTIMATE Robotic Pool Cleaner | User Instructions
Assemble the impeller compartment according to the next steps:
6.3.5
6.3.6
6.4 Periodic general maintenance - Recommended at least once a week
• When the cable is wet, spread it flat and straight in the yard, and allow it to dry for at least five
hours to avoid twisting of the cable.
• Wash the Robotic Pool Cleaner with fresh water, to reduce damage caused by the chemicals in the
pool water.
7. OFF-SEASON STORAGE
If the Robotic Pool Cleaner will not be in use for an extended period of time, perform the following
storage steps:
• Make sure that no water is left in the Robotic Pool Cleaner.
• Thoroughly clean the filter basket and panels and insert them back in place.
• Roll up the cable so that it has no kinks.
• Store the Robotic Pool Cleaner in a protected area out of direct sun/rain/frost, at a temperature
of between 5°-45°C / 41°-113°F.
5°C
41°F
45°C
113°F
To Next Page
Loading...
