Mazda 3 2020 - Page 166

NOTE

After starting the engine, the push
button start indicator light
(amber) turns o and the ignition
switches to the ON position.

(SKYACTIVG
1.5,
SKYACTIVG
2.0, SKYACTIVX 2.0,
SKYACTIVG 2.5)
After pressing the push button
start and before the engine starts,
the operation sound of the fuel
pump motor from near the fuel
tank can be heard, however, this
does not indicate a malfunction.

(SKYACTIVD 1.8)

The starter does not rotate until
the glow indicator light turns
o.

If the ignition is left switched
ON for a long period of time
without the engine running
after the glow plugs are
warmed up, the glow plugs may
warm up again which will
illuminate the glow indicator
light.

When starting the engine, do
not release the clutch pedal
(manual transmission) or the
brake pedal (automatic
transmission) until the glow
indicator light in the instrument
cluster turns o and the engine
starts, after pressing the push
button start.

If the clutch pedal (manual
transmission) or the brake
pedal (automatic transmission)
is released before the engine
starts, depress the clutch pedal
(manual transmission) or the
brake pedal (automatic
transmission) again and press
the push button start to start
the engine.
8. After starting the engine, let it idle
for about 10 seconds (Prohibited in
Germany).
NOTE

(Germany)
Drive immediately after starting
the engine. However do not use
high engine speeds until reaching
the operating temperature.

(SKYACTIVG 1.5, SKYACTIVG
2.0, SKYACTIVX 2.0,
SKYACTIVG 2.5)

Whether the engine is cold or
warm, it should be started
without the use of the
accelerator.

If the engine does not start the
first
time, refer to Starting a
Flooded Engine under
Emergency Starting. If the
engine still does not start, have
your vehicle inspected by an
expert repairer (we recommend
an Authorised Mazda Repairer)
(page 7-46).
When Driving
Start/Stop Engine
4-8
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36