Mazda 3 2020 - Smart Brake Support [Rear] (SBS-R)

Smart Brake Support
[Rear] (SBSR)
*
▼
Smart Brake Support [Rear]
(SBSR)
The SBSR is a system which is
designed to reduce damage in the
event of a collision by operating the
brake control (SBS brake) when the
system’s sensors detect an obstruction
at the rear of the vehicle while driving
at a speed of about 2 to 8 km/h (2 to
4 mph) and the system determines that
a collision is unavoidable.
WARNING
Do not rely completely on the SBSR
system:
The
SBSR
system is only designed to
reduce damage in the event of a
collision. Over reliance on the system
leading to the accelerator pedal or
brake pedal being mistakenly
operated could result in an accident.
To assure the correct operation of
the
SBSR,
heed the following
cautions.
Do not apply a sticker to a rear
ultrasonic sensor and rear camera.
Otherwise, the rear ultrasonic
sensor and rear camera may not be
able to detect vehicles or
obstructions which could result in
an accident.
Do not disassemble a rear
ultrasonic sensor and rear camera.
If cracks or damage caused by
flying gravel or debris is visible
around a rear ultrasonic sensor and
rear camera, stop using the SBSR
system immediately and have your
vehicle inspected by an expert
repairer (we recommend an
Authorised Mazda Repairer). If the
vehicle continues to be driven with
cracks or scratch marks left around
an ultrasonic sensor, the system
may operate unnecessarily and
cause an unexpected accident.
Refer to Stopping the Smart Brake
Support [Rear] (SBSR) System
Operation on page 4-192.
Consult an expert repairer (we
recommend an Authorised Mazda
Repairer) for rear bumper
replacement.
Do not modify the suspension:
If the vehicle height or inclination is
changed, the SBSR system may not
operate correctly because it cannot
detect obstructions correctly.
When Driving
i-ACTIVSENSE
*Some models.
4-189
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36