Mazda 3 2020 - Page 310

▼
Setting the System
The MRCC with Stop & Go function system operates when all of the following
conditions are met.

The vehicle speed is as follows:

(European models)
About 0 km/h (0 mph) to 200 km/h (125 mph)

(Except European models)
About 0 km/h (0 mph) to 145 km/h (90 mph)

The MRCC with Stop & Go function is turned on.

The brake pedal is not depressed.

The parking brake is released (Electric Parking Brake (EPB) indicator light is turned
o).

There is no problem with the DSC.

All the doors are closed.

The driver's seat belt is fastened.

The selector lever is in the drive (D) position or manual (M) position (manual
mode).
NOTE

In the following cases, the MRCC with Stop & Go function system is cancelled
when the vehicle is travelling at 30 km/h (20 mph) or less and “Mazda Radar
Cruise Control Disabled Under 30 km/h (20mph)” is displayed in the
multi-information display.

The Forward Sensing Camera (FSC) cannot detect target objects (There is
problem with the Forward Sensing Camera (FSC) or windscreen is dirty).

There is a problem with the stop hold control function.

There is a problem with the Electric Parking Brake (EPB).

When the MRCC with Stop & Go function system is operating, Distance & Speed
Alert (DSA), and Smart Brake Support (SBS) also turns on automatically.

It may not be possible to set the MRCC with Stop & Go function system directly
after starting the engine, while the DSC operation is being checked.
Turning on the system
1. CANCEL switch
2. RES switch
When Driving
i-ACTIVSENSE
4-152
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36