Mazda 3 2020 - Page 314

Cancelling the system
When the following operations are
performed, the MRCC with Stop & Go
function system is cancelled, and the
MRCC with Stop & Go function set
indication (green) switches to the
MRCC with Stop & Go function
standby indication (white) at the same
time.

The CANCEL switch is pressed.

The brake pedal is depressed.

The selector lever is in the P (Park), N
(Neutral), or R (Reverse) position.
Under the following conditions, the
MRCC with Stop & Go function cancel
indication is displayed in the
multi-information display and a single
beep sound is heard.

The DSC has operated.

The Smart Brake Support (SBS) has
operated.

When travelling on a downslope for
a long period of time.

There is a problem with the system.

The parking brake is automatically
applied during stop hold control.

The front radar sensor cannot detect
target objects (during rain, fog, snow
or other inclement weather
conditions, or when the radiator
grille is dirty).

The parking brake is applied.

Any of the doors is opened.

The driver's seat belt is unfastened.

The operation frequency of the
braking by the MRCC with Stop &
Go function control is high.
Resuming control
If the MRCC with Stop & Go function
system is cancelled, you can resume
control at the previously set speed by
pressing the RES switch and after all of
the operation conditions have been
met.
NOTE
If the set speed is not indicated in the
display, the control does not resume
even if the RES switch is pressed.
Turning
o
the system
When the MRCC switch is pressed
while the MRCC is operating, the
MRCC turns o.
▼
Stop Hold Control
While in headway control using the
MRCC with Stop & Go function
system, your vehicle will stop when a
vehicle ahead stops. When the vehicle
is stopped and the stop hold control
operates, the MRCC with Stop & Go
function indicator light turns on.
NOTE

If the MRCC with Stop & Go
function system is cancelled during
stop hold control, the vehicle is held
in its stopped position.

The parking brake is automatically
applied and the vehicle is held in its
stopped position when 10 minutes
have elapsed since the stop hold
control operated. At this time, the
MRCC with Stop & Go function
system is cancelled.
When Driving
i-ACTIVSENSE
4-156
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36