Mazda 3 2020 - Page 317

When entering and exiting
interchanges, service areas, and
parking areas of expressways (If you
exit an expressway while headway
control is in use, the vehicle ahead
will no longer be tracked and your
vehicle may accelerate to the set
speed).
Slippery roads such as icy or
snow-covered roads (Tyres could
spin causing you to lose vehicle
control, or the stop hold control may
not operate.)
Long, descending slopes (to
maintain distance between vehicles,
the system automatically and
continuously applies the brakes
which could result in the loss of
brake power.)
Two-wheeled vehicles such as
motorcycles or bicycles are ahead.
(Automatic transmission vehicle)
Slopes with a steep gradient (The
vehicle ahead may not be detected
correctly, your vehicle may slip while
stopped by the stop hold control, or
it may accelerate suddenly after it
starts moving.)
Driving under bad weather
conditions (rain, fog, and snow).
The vehicle is driven on slippery
roads such as icy or snow -covered
roads and unpaved roads (Tyres
could spin causing you to lose
vehicle control, or the stop hold
control may not operate.)
Tyres of a dierent specified size are
used, such as a temporary spare tyre.
Tyres with insucient tread are used.
The tyre pressures are not adjusted to
the
specified
pressure.
The vehicle is being used to tow a
camper or boat trailer.
Tyre chains are used.
The vehicle is driven on roads with
lane lines other than white (yellow)
lines, such as an expressway.
Do not get out of the vehicle while
the stop hold control is operating.
(Automatic transmission vehicle)
Getting out of the vehicle while the
stop hold control is operating is
dangerous as the vehicle may move
unexpectedly and result in an accident.
Before getting out of the vehicle,
switch the CTS o, apply the parking
brake, and then shift the selector lever
to the P position.
CAUTION
Turn the system o when the vehicle is
running on a chassis roller.
Heed the following cautions so that
the CTS can operate normally.
Turn the system o when the vehicle
is running on a chassis roller.
Do not modify the vehicle's
suspensions.
Always use wheels of the specified
size for the front and rear wheels.
Consult an expert repairer (we
recommend an Authorised Mazda
Repairer) for tyre replacement.
NOTE

The headway control does not detect
the following as physical objects.

Vehicles approaching in the
opposite direction

Pedestrians

Stationary objects (stopped
vehicles, obstructions)
When Driving
i-ACTIVSENSE
4-159
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36