▼
Intelligent Speed Assistance (ISA) Display
The setting status of the ISA is displayed in the active driving display or the display in
the instrument cluster.
Status
Indication on
multi-informa-
tion display/
active driving
display
Explanation
Stand-by dis-
play
Displays when the speed limiter switch is operated and the system
is turned on.
Turns o when the system is turned o.
Setting display
Displays when the RES switch up (SET+) or down (SET) is operated
(while the ISA set indication is displayed), and the speed is set.
Cancel display
Displays when any of the following operations is done and the sys-
tem is temporarily cancelled.
CANCEL switch is operated
Accelerator pedal is strongly depressed
Any door is opened
The driver’s seat belt is unfastened
Warning display
If the vehicle speed exceeds the set speed by about 5 km/h (3
mph) or more, the ISA display
flashes.
The display flashes until the vehicle speed decreases to the set
speed or less.
A warning beep is activated at the same time as the warning dis-
play.
Refer to Speed Limiter Warning Beep on page 7-79.
▼
Activation/Deactivation
NOTE
When the ignition is switched
o,
the
system status before it was turned
o
is
maintained.
For example, if the ignition is switched
o while the ISA is operating, the
system will be operable when the
ignition is switched ON the next time.
Activation
Press the LIM switch to activation the
system. The ISA screen is displayed,
and the ISA standby indication displays
in white.
Deactivation
Press the LIM switch again to
deactivation the system. The ISA screen
is no longer displayed and the ISA
indication does not display.
When Driving
i-ACTIVSENSE
4-183
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36
To Next Page
Loading...
