The obstruction is extremely close.
In the following cases, the rear
ultrasonic sensor and rear camera
cannot detect obstructions correctly
and the SBSR may not operate.
Something is stuck on the bumper
near a rear ultrasonic sensor.
The brake or accelerator pedal is
operated.
There is another obstruction near
one obstruction.
During inclement weather such as
rain, fog and snow.
High or low humidity.
High or low temperatures
Strong winds.
The path of travel is not flat.
Heavy luggage is loaded in the
luggage compartment or on the
rear seat.
Objects such as a wireless aerial,
fog light, or illuminated number
plate is installed near a rear
ultrasonic sensor.
The orientation of a rear ultrasonic
sensor has deviated for reasons
such as a collision.
The vehicle is
aected
by other
sound waves such as the horn,
engine noise, ultrasonic sensor of
another vehicle.
In the following cases, a rear
ultrasonic sensor and rear camera
may detect something as a target
obstruction which could cause the
SBSR system to operate.
Driving on a steep slope.
Wheel blocks.
Hanging curtains, gate poles such
as at toll gates and railroad
crossing.
When travelling near objects such
as foliage, barriers, vehicles, walls,
and fences along a road.
When driving o-road in areas
where there is grass and forage.
When passing through low gates,
narrow gates, car washing
machines, and tunnels.
A trailer is connected.
A bright light source such as
sunlight hits the rear camera.
The surroundings are dark.
An exterior accessory such as a
bicycle carrier is installed around a
rear ultrasonic sensor.
(Manual transmission)
If the vehicle is stopped by the SBSR
operation and the clutch pedal is not
depressed, the engine stops.
When the system operates, the user
is notified by the multi-information
display.
The collision warning beep sounds
intermittently while the SBSR brake
is operating.
If the vehicle is stopped by the SBSR
operation and the brake pedal is not
depressed, displaying in meter
“Emergency Braking Activated.
Depress Brake Pedal to Hold Stop”,
after about 2 seconds and the SBSR
brake is automatically released.
If a Mazda genuine trailer hitch is
used, the SBSR is automatically
turned o.
Turn o the SBSR system while
pulling a trailer or while an accessory
such as a bicycle carrier is installed to
the rear of the vehicle.
When Driving
i-ACTIVSENSE
4-191
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36