1. First, adjust the front seat to allow
clearance between the
child-restraint system and the front
seat.
Refer to Adjusting the Driver's Seat
on page 2-5.
Refer to Adjusting the Front
Passenger's Seat on page 2-13.
2. Make sure the seatback is securely
latched by pushing it back until it is
fully locked.
3. Remove the cover of the
child-restraint system's ISOFIX
anchors to verify the locations of
the ISOFIX anchors.
1. ISOFIX anchor
NOTE
The ISOFIX anchors marking on
the cover indicates the position of
the ISOFIX anchors for the
attachment of a child-restraint
system.
Store the removed cover so that it
does not get lost.
4. Remove the head restraint.
However, when installing a booster
seat, always install the vehicle head
restraint to the seat where the
booster seat is installed.
Refer to Head Restraints on page
2-17.
5. Secure the child-restraint system
using the ISOFIX anchor, following
the child-restraint system
manufacturer's instruction.
6. If your child-restraint system came
equipped with a tether, that
probably means it is very important
to properly secure the tether for
child safety. Please carefully follow
the child-restraint system
manufacturer's instructions when
installing tethers (page 2-44).
WARNING
Always attach the tether strap to the
correct tether anchor position:
Attaching the tether strap to the
incorrect tether anchor position is
dangerous. In a collision, the tether
strap could come
o
and loosen the
child-restraint system. If the
child-restraint system moves it could
result in death or injury to the child.
Essential Safety Equipment
Child Restraint
2-46
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36
To Next Page
Loading...
