Mazda 3 - Dtc P0011 [Z6]

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
Downloaded from https://carmanualshub.com/ - automotive repair manuals website
44
DTC P0011 [Z6]
B3E010200001W01
DTC P0011
CMP-timing over-advanced
DETECTION
CONDITION
• The actual valve timing is over-advanced from the target valve timing when the
OCV is controlled within the maximum valve timing retard condition.
Diagnostic support note
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in the first
drive cycle.
• PENDING CODE is available if the PCM detects the above malfunction condition.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.
POSSIBLE CAUSE
• OCV malfunction
• Spool valve in OCV is stuck in advance position.
• Variable valve timing actuator is stuck in advance position.
• Loose timing chain or improper valve timing due to timing chain slippage
• PCM malfunction
Diagnostic procedure
STEP
INSPECTION
ACTION
1
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
• Has FREEZE FRAME DATA been
recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair
order, then go to the next step.
2
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
• Verify related service repair information
availability.
• Is any related repair information
available?
Yes
Perform repair or diagnosis according to the
available repair information.
• If the vehicle is not repaired, go to the next
step.
No
Go to the next step.
3
INSPECT OCV FOR MALFUNCTION
• Start the engine.
• Increase the engine speed.
• Stop the engine.
• Remove the OCV.
Yes
Go to the next step.
No
Replace the OCV, then go to Step 6.
(See OIL CONTROL VALVE (OCV)
REMOVAL/INSTALLATION [Z6].)