Mazda 3 - Fresh-Air Duct Removal Note; Intake Manifold Removal Note; Air Cleaner Case Installation Note

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
Downloaded from https://carmanualshub.com/ - automotive repair manuals website
793
8
Fresh-air duct
(See Fresh-air Duct Removal Note.)
9
Throttle body
10
Variable intake air solenoid valve
11
Variable tumble solenoid valve
12
Fuel distributor
(See FUEL INJECTOR REMOVAL/INSTALLATION [LF].)
13
IAC solenoid valve
14
Intake manifold
(See Intake Manifold Removal Note.)
15
EGR pipe gasket
Fresh-air Duct Removal Note
1. Remove the front bumper before removing the fresh-air duct. (See FRONT BUMPER
REMOVAL/INSTALLATION.)
Intake Manifold Removal Note
1. Remove the dipstick pipe. (See OIL PAN REMOVAL/INSTALLATION [LF].)
2. Remove the accelerator cable bracket from the intake manifold.
Air Cleaner Case Installation Note
Note
• Before installing the air cleaner case, verify that the rubber mounts on the battery support
bracket have not fallen off.
• When inserting the air cleaner case into the rubber mounts, applying soapy water aids the
operation.
1. Verify that two rubber mounts are installed on the battery support bracket.
2. Install the air cleaner case into the rubber mounts.