Mazda 3 - Starter Removal;Installation [Lf]

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
Downloaded from https://carmanualshub.com/ - automotive repair manuals website
894
1
Terminal B cable
2
Terminal S connector
3
Wiring harness clip
4
Starter
STARTER REMOVAL/INSTALLATION [LF]
B3E011918400W04
Warning
• When the battery cables are connected, touching the vehicle body with starter terminal B will
generate sparks. This can cause personal injury, fire, and damage to the electrical components.
Always disconnect the negative battery cable before performing the following operation.
1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF].)
2. Disconnect the negative battery cable.
3. Remove the under cover.
4. Remove the clutch release cylinder. (MTX) (See MANUAL TRANSAXLE REMOVAL/INSTALLATION
[F35M-R].)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.