Mazda 3 - Generator Drive Belt

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
Downloaded from https://carmanualshub.com/ - automotive repair manuals website
686
Tightening torque
17.6-26.5 N·m
{1.8- 2.7kgf·m, 13.0-19.5ft·lbf}
7. Install the engine under cover and splash shield (RH).
Generator Drive Belt
1. Remove the plug hole plate.
(See PLUG HOLE PLATE REMOVAL/INSTALLATION [LF].)
2. Remove the A/C drive belt.
3. Turn the center of the auto tensioner pulley counterclockwise to release tension to the drive belt
tension.
4. Remove the generator drive belt.
5. Install a new generator drive belt.
6. Verify that the generator drive belt auto tensioner indicator mark does not exceed the limit. (SeeDRIVE
BELT REPLACEMENT [LF].)
• If it exceeds the limit, replace the drive belt.
7. Install the A/C drive belt.
8. Install the plug hole plate.
(See PLUG HOLE PLATE REMOVAL/INSTALLATION [LF].)