Mazda 3 - Crankshaft Pulley Installation Bolt Removal Note

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
Downloaded from https://carmanualshub.com/ - automotive repair manuals website
660
1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the drive belt. (See DRIVE BELT REPLACEMENT [Z6].)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
1
Crankshaft pulley installation bolt
(See Crankshaft Pulley Installation Bolt Removal Note)
(See Crankshaft Pulley Installation Bolt Installation Note)
2
Crankshaft pulley
3
Front oil seal
(See Front Oil Seal Removal Note)
(See Front Oil Seal Installation Note)
Crankshaft Pulley Installation Bolt Removal Note
1. Fix the crankshaft pulley using the SSTs.
2. Remove the crankshaft pulley installation bolt.