CAUTION
¾Do not shade the light sensor by adhering a sticker or a label on the windscreen. Otherwise
the light sensor will not operate correctly.
¾The light sensor also works as a rain sensor for the auto-wiper control. Keep hands and
scrapers clear of the windscreen when the wiper lever is in the AUTO position and the
ignition is switched ON as ngers could be pinched or the wipers and wiper blades
damaged when the wipers activate automatically. If you are going to clean the windscreen,
be sure the wipers are turned o completely ― this is particularly important when clearing
ice and snow ― when it is particularly tempting to leave the engine running.
NOTE
x
The headlights, other exterior lights and instrument panel illumination may not turn off
immediately even if the surrounding area becomes well-lit because the light sensor
determines that it is night time if the surrounding area is continuously dark for several
minutes such as inside long tunnels, traffic jams inside tunnels, or in indoor parking lots.
In this case, the lights turn off if the light switch is turned to the
position.
x
When the headlight switch is in the AUTO position and the ignition is switched to ACC or
the ignition is switched off, the headlights, other exterior lights and instrument panel
illumination will turn off.
x
The instrument panel illumination can be adjusted by rotating the knob in the instrument
cluster. Also, the antidazzle mode can be changed by rotating the knob until a beep sound
is heard. To adjust the brightness of the instrument panel illumination: Refer to
Instrument Panel Illumination on page 4-27.
x
The sensitivity of the AUTO lights may be changed by an Authorised Mazda Repairer.
Refer to Personalisation Features on page 9-13.
When Driving
Switches and Controls
4-62
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52
To Next Page
Loading...
