NOTE
x
The DAA operates when all of the following conditions are met.
x
The vehicle speed is about 65 to 140 km/h (41 to 86 mph).
x
The system detects white (yellow) lane lines.
x
The system has completed learning of the driver’s driving data.
x
The DAA does not operate under the following conditions.
x
The vehicle speed is less than about 65 km/h (41 mph).
x
The vehicle speed exceeds about 140 km/h (86 mph)
x
The vehicle is making a sharp turn.
x
The vehicle is changing lanes.
x
The system cannot detect white (yellow) lane lines.
x
The DAA may not operate normally under the following conditions.
x
White (yellow) lane lines are less visible because of dirt or fading/patchiness.
x
The vehicle is jolted or swayed continuously by strong winds or rough roads.
x
The vehicle is driven aggressively.
x
When making frequent lane changes.
x
The DAA detects driver fatigue and decreased attentiveness based on the driving data
when the vehicle is driven at about 65 to 140 km/h (41 to 86 mph) for about 20 minutes.
The driving data will be reset under the following conditions.
x
The vehicle is stopped for 15 minutes or longer.
x
The vehicle is driven at less than about 65 km/h (41 mph) for about 30 minutes.
x
The ignition is switched off.
x
After the DAA has displayed the first message encouraging rest, it does not display the
next one until 45 minutes have passed.
▼
Driver Attention Alert (DAA)
Display
When the system detects driver fatigue or
decreased attentiveness, it activates the
warning sound and displays an alert in the
active driving display.
▼
Cancelling Driver Attention Alert
(DAA)
The DAA can be set to not activate.
Refer to Personalisation Features on page
9-13.
When Driving
i-ACTIVSENSE
4-136
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52
To Next Page
Loading...
