Mazda CX-3 - Page 42

Maintenance and Care
Selector
Vehicle Engine Control Unit Reset Procedure
NOTE
The initialization (engine oil data resetting) of the recorded value can be
performed using the following procedure:
1. Switch the ignition OFF.
2. Switch the ignition ON with the selector pressed, and press and hold the
selector for about 5 seconds until the master warning light flashes.
3. After the master warning light flashes for several seconds, the
initialization is completed.
Whenever the engine oil is replaced, the vehicles engine control unit needs to be
reset as soon as possible. Otherwise the wrench indicator light or engine oil warning
light may turn on. To reset the engine control unit, consult an expert repairer, we
recommend an Authorised Mazda Repairer or refer to the vehicle engine control
unit reset procedure.
39
For details, refer to Section 6, “Owner Maintenance”.
CX-38GT4EE18DEdition8QuickGuide.indb41CX-38GT4EE18DEdition8QuickGuide.indb41 2019/11/229:08:022019/11/229:08:02