Mazda CX-3 - Page 617

CAUTION
¾Using oils of viscosity besides those recommended for
specic
temperature ranges could
result in engine damage.
¾(SKYACTIV-D 1.5 and SKYACTIV-D 1.8)
SKYACTIV-D 1.5 and SKYACTIV-D 1.8 use specied oil. Please conrm the specication in
owner's manual. If engine oil other than the
specied
oil is used, the Diesel Particulate Filter
eective period of use will be shortened or the Diesel Particulate Filter may be damaged.
NOTE
(SKYACTIV-G 2.0)
x
It is normal for all engines to consume engine oil under normal driving conditions.
Engine oil consumption may be as high as 0.8 L/1,000 km (1 L/800 miles). This may be as
a result of evaporation, internal ventilation or burning of the lubricating oil in the
working engine. Oil consumption may be higher when the engine is new due to the
running-in process. Oil consumption is also dependant on engine speed and engine load.
Under extreme driving conditions, oil consumption may be higher.
(SKYACTIV-D 1.5 and SKYACTIV-D 1.8)
x
Whenever the engine oil is replaced, the vehicles engine control unit needs to be reset as
soon as possible. Otherwise the wrench indicator light or engine oil warning light may
turn on. To reset the engine control unit, consult an expert repairer (we recommend an
Authorised Mazda Repairer) or refer to the vehicle engine control unit reset procedure on
page 6-27.
x
Inspect the engine oil level periodically. When inspecting the engine oil, if the engine oil
level is exceeds the “X” mark on the dipstick, replace the engine oil. This should be done
by an expert repairer (we recommend an Authorised Mazda Repairer). When replacing
the engine oil, inspect the oil level using the oil dipstick and refill so that the engine oil
level is within the range between MIN and MAX as shown in the figure.
X MarkMAXMIN
Maintenance and Care
Owner Maintenance
6-26
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52