Auto cancel
In the following cases, the LAS&LDWS is
automatically canceled, the LAS&LDWS
warning indication (amber) turns on, and
an alert is displayed. When the
LAS&LDWS become operational, the
system turns back on automatically.
•
The temperature inside the camera is
high or low.
•
The windshield around the camera is
foggy.
•
The windshield around the camera is
blocked by an obstruction, causing poor
forward visibility.
Auto cancel of warning/steering assist
When the following operations are
performed, the LAS&LDWS operation is
canceled automatically. The LAS&LDWS
resumes automatically after the operation.
•
The steering wheel is operated abruptly.
•
The brake pedal is operated.
•
The accelerator pedal is operated.
(To cancel the automatic sensitivity
cancel function, deselect “Cancel
sensitivity” in the personalization
features setting.)
•
The turn signal lever is operated.
•
The vehicle crosses a lane line.
NOTE
•
After the operation, the LAS&LDWS
operation may not operate for a period
of 5 seconds at the most until the lane
lines are detected.
•
Under the following conditions, the
LAS&LDWS cancels the warning/
steering assist automatically.
•
The driver takes his/her hands off the
steering wheel.
(The LAS&LDWS is designed to assist
the driver's steering operation and it
will resume operation automatically
when the driver holds the steering
wheel.)
•
The TCS OFF switch is pressed to
cancel the TCS.
When Driving
i-ACTIVSENSE
4-137
CX-5_8GB6-EA-17G_Edition1 2017-5-18 10:43:27
To Next Page
Loading...
