Child-Restraint System Suitability for Various Seat
Positions Table
(Mexico)
Provided information in the table shows your child-restraint system suitability for various
seating position. For installation suitability of other manufacturer child-restraint system,
carefully consult the manufacturer's instructions which accompany the child-restraint
system.
When installing a child-restraint system, the following points must be observed:
•
If the child-restraint system does not fit into the seatback because of the head restraint,
adjust the head restraint or remove the head restraint so that the child-restraint system fits
into the seatback. However, when installing a backless booster seat, always install the
vehicle head restraint to the seat where the backless booster seat is installed.
Refer to Head Restraints on page 2-16.
•
When installing a child-restraint system to the rear seat, adjust the front seat position so
that the front seat does not contact the child-restraint system.
Refer to Seat Operation on page 2-5.
•
When installing a child-restraint system came equipped with a tether, remove the head
restraint.
Refer to Head Restraints on page 2-16.
LATCH lower anchor-secured child-restraint systems
When installing a child-restraint system to the rear seat, refer to the child-restraint system
manufacturer's instructions and the Using LATCH Lower Anchor on page 2-44.
Mass group
Size
Class
Fixture
Seat Positions
Vehicle LATCH po-
sitions
Rear seat (center)
Front passenger
seat (outboard)
Rear seat (out-
board)
Carrycot
FISO/L1 X X X
GISO/L2 X X X
(1) X X X
GROUP 0 Up to 10
kg (up to 22 lb)
EISO/R1 IL X X
(1) X X X
GROUP 0
Up to
13 kg (up to 29 lb)
EISO/R1 IL X X
DISO/R2 IL X X
CISO/R3 IL X X
(1) X X X
Essential Safety Equipment
Child Restraint
2-33
CX-5_8GB6-EA-17G_Edition1 2017-5-18 10:43:27
To Next Page
Loading...
