5. Insert the end of the new blade rubber
into the groove of the blade holder
until it contacts the end of the blade
holder.
Groove
6. After pulling the blade rubber in the
direction of the arrow and sliding the
blade rubber to a position to check the
blade holder groove, slide the blade
rubber end in the opposite direction.
Groove
7. Make sure that the blade rubber is
correctly installed to the blade holder.
8. Align the wiper arm tabs with the
blade component grooves.
Tabs
Grooves
Maintenance and Care
Owner Maintenance
6-37
CX-5_8GB6-EA-17G_Edition1 2017-5-18 10:43:27
To Next Page
Loading...
