Signal Warning Action to be taken
Seat Belt Warning
Light
Except Mexico
The seat belt warning light turns on if the
driver or front passenger's seat is occupied
and the seat belt is not fastened with the ig-
nition switched ON.
If the driver or front passenger's seat belt is
unfastened (only when the front passenger's
seat is occupied) and the vehicle is driven at
a speed faster than about 20 km/h (12 mph),
the warning light flashes. After a short time,
the warning light stops flashing, but re-
mains illuminated.
NOTE
•
The warning light flashes for about 6 sec-
onds if the driver's seat belt is not fastened
when the ignition is switched ON.
•
To allow the front passenger occupant
classification sensor to function properly,
do not place and sit on an additional seat
cushion on the front passenger's seat. The
sensor may not function properly because
the additional seat cushion could cause
sensor interference.
•
If a small child is seated on the front pas-
senger's seat, the warning light may not
operate.
Fasten the seat belts.
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-35
CX-5_8GB6-EA-17G_Edition1 2017-5-18 10:43:27
To Next Page
