Mazda CX-5 - Page 489

3. Input the PIN code of your Bluetooth
®
audio device by pressing channel
preset buttons 1 to 4 while “PIN 0000”
is displayed.
Press channel preset button 1 to input
the first digit, 2 for the second, 3 for
the third, and 4 for the forth. For
example, if the PIN code were “4213”,
press channel preset button 1 four
times (1, 2, 3, 4), button 2 twice (1, 2),
button 3 once (1), and button 4 three
times (1, 2, 3). If the “PIN 0000”
display disappears before finishing the
PIN code input, repeat the procedure
from Step 1.
NOTE
Some devices accept only a particular
pairing code (Usually, “0000” or
“1234”). If pairing cannot be
completed, refer to the owner's manual
of your mobile device, and try those
numbers if necessary.
4. Press the audio control dial while the
input PIN code is displayed.
“PAIRING” flashes on the display.
5. Operate the Bluetooth
®
audio device
and set it to the pairing mode while
“PAIRING” is flashing.
6. When the pairing is completed, “
”
and “PAIR SUCCESS” are displayed
after about 10-30 seconds, after which
“PAIR SUCCESS” continues to be
displayed for three seconds, and then
the unit returns to the normal display.
NOTE
l
Some Bluetooth
®
audio devices need
a certain amount of time before the
“
” symbol is displayed.
l
If the pairing failed, “Err” flashes for
three seconds.
l
Pairing cannot be performed while
the vehicle is moving. If you attempt
to perform pairing whi le the vehicle
is moving, “PAIR DISABLE” is
displayed.
l
If seven Bluetooth
®
audio devices
have already been paired to the
vehicle, pairing cannot be performed
and “MEMORY FULL” is
displayed. Delete one paired device
to pair another one.
Pairing a Bluetooth
®
audio device
which does not have a four-digit PIN
code
1. Using the audio control dial, select the
pairing mode “PAIR DEVICE” in the
“BT SETUP” mode. (Refer to
“Bluetooth
®
audio set up” for details.)
2. Press the audio control dial to
determine the mode. After “ENTER
PIN” is displayed on the audio display
for three seconds, “PIN 0000” is
displayed and the PIN code can be
input.
3. Press the audio control dial while “PIN
0000” is displayed. “PAIRING” flashes
on the audio display.
4. Operate the Bluetooth
®
audio device
and set it to the pairing mode while
“PAIRING” is flashing.
Interior Features
Bluetooth®
5-99