Mazzer Philos - 4 Installation and Wiring

4. INSTALLATION AND WIRING
Incorrect installation may result in
injury of persons or animals, or
damage to property, for which the
manufacturer cannot be held
responsible.
• On opening the packaging, check
carefully to make sure the appliance
is intact and that there are no signs
of damage. If in any doubt, do not
use the unit and contact your service
reference.
• The appliance must be placed on a
stable, flat surface (we recommend
to install the appliance at an height
between 80 and 100 cm from the
floor).
• Before plugging in the appliance,
make sure the voltage and
frequency values of the supply
mains correspond to the technical
data indicated on the label
positioned on the bottom of the
grinder.
• The wall socket must be fitted with
an efficient earth contact.
Consequently, it is essential to make
sure the earth system is efficient and
in conformity with current safety
rules. If in any doubt, have the
system thoroughly checked by
personnel with the appropriate
professional skills.
It is compulsory to earth the
appliance. The manufacturer
cannot be held responsible in the
event this regulation is not
complied with.
• It is essential to make sure the
ratings of the system are suitable for
the power absorbed by the
appliance - as indicated on the label
featuring the technical data - and
that the wall socket is protected
against overcurrents.
• Do not use extension cables, plug
adapters for multiple sockets or
makeshift connections.
• The appliance is suitable for indoor
use only. Do not install the appliance
outdoors.
• For an optimal functioning of the
appliance a room temperature range
from 15°C to 35°C is suggested.
• Thoroughly clean the appliance at
the first installation; follow the
instructions in chapter 8.
• The appliance is not suitable for
installation in an area where a water
jet could be used.
• For the correct use of the grinding
blades, at the first installation or
whenever the grinding blades have
been replaced, grind some doses of
coffee. Do not use those first doses.
• A minimum clearance of 15 cm (6.0
inches) is required between the
grinder and any adjacent walls (or
other adjacent appliances). Frontal
side must be open.
• Do not install the appliance near to
water dispenser or similar product
that could throw water jet on the
appliance.
• If required, the power cord can be
shortened, proceed as follows:
loosen the pin by turning it
counterclockwise, remove the back
base cover, pass the power cord
through the cover and fit it in to the
10