24
Possible causes of errors for a fault (status LED flashes in red)
1. Faults must always be acknowledged by disconnecting the charging cable plug, and may be
triggered by the following causes, for example:
General errors (displayed in red and white)
"white/white/white/red"
Error 1 [0001]
1. The vehicle was disconnected again during
the Wallbox self-tests (status LED lit in
orange).
2. The charging cable plug was disconnected
during the charging process:
The charging cable plug was not correctly
locked – disconnect the charging cable plug
and reconnect correctly, ensuring that it
locks properly.
"white/white/red/white"
Error 2 [0010], version with charging
socket only
BMW fast charging cable not recognised:
Disconnect and reconnect the fast charging
cable; have it checked at the workshop if
necessary.
"white/white/orange/orange"
Error 3 [0011]
Temperature cut-out:
The maximum temperature in the Wallbox was
exceeded. After briefly displaying the error code,
status LED segments S2 and S4 will flash in
orange until the Wallbox has cooled down.
To Next Page
Loading...