EasyManua.ls Logo

McConnel RoboCut - General Machine Information; Manual Definitions and Usage

McConnel RoboCut
130 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
GENERAL INFORMATION
Always read this manual before attempting to operate the machine – whenever any doubt exists
contact your dealer or the McConnel Service Department for advice and assistance.
Use only McConnel Genuine Service Parts on McConnel Equipment and Machines
DEFINITIONS The following definitions apply throughout this manual:
WARNING
An operating procedure, technique etc., which –
can result in personal injury or loss of life if not observed carefully.
CAUTION
An operating procedure, technique etc., which –
can result in damage to either machine or equipment if not observed carefully.
NOTE
An operating procedure, technique etc., which is –
considered essential to emphasis.
LEFT AND RIGHT HAND
These terms are applicable to the machine when it is viewed from the rear facing forwards.
Note: The illustrations in this manual are for instructional purposes only and may on occasion not show
some components in their entirety. In some instances an illustration may appear slightly different to that of
your particular model but the general procedure will be the same. E&OA.
MACHINE & DEALER INFORMATION
Record the Serial Number of your machine on this page and always quote this number when
ordering parts. Whenever information concerning the machine is requested remember also
to state the make and model of tractor to which the machine is fitted.
Machine Serial Number: Installation Date:
Machine Model details:
Dealer Name:
Dealer Address:
Dealer Telephone No:
Dealer Email Address:

Related product manuals