24
PRE-OPERATION CHECKS
WARNING! All checks or inspections of the machine should be performed with
the machine parked on firm level ground with the engine switched off and the
starting key removed.
The following checks should be made daily before using the machine;
Check all safety guarding is in good condition and fitted correctly.
Check nuts and bolts for tightness, retighten if required.
Check flail head for damaged or missing flails – replace if required before use.
Check oil, coolant and fuel levels, replenish if required.
Check filters – clean or replace if required.
Check radiator matrix is clean – clear blockages if required using compressed air.
Lubricate machine as per details stated in the maintenance section.
Work and Work Area Precautions
Always ins pect the work area prior to operat ions; check for and remove foreign bodies
such as large stones, metal component, wire and glass etc. which could damage
machine c omponent or be eject ed by the f lail head. Any immov eable obje ct should be
visually marked or avoided.
Ensure the area is c lear of anim als and persons. Never manoeuvre the machine into a n
area where you can no longer see it working.
Only work the machine in grass or brus hwood that is within its cutting capabilit y;
attempting to cut materials beyond the machines capability will damage components.
When working on slopes always start at the bottom and work up.
Never run the machine down a slope that is in excess of its track option capability.
Never operate the machine on slopes or ground where there is a risk of overturn.
To Next Page
Loading...
