4
Operators should practice operation on flat open ground to familiarise themselves with
driving and manoeuvring the machine before attempting to use it on sloping ground.
Operators should practice manoeuvring the machine around obstacles without the flail head
running before using the machine for work purposes.
Never operate the machine when your vision is blocked by obstacles such as vehicles,
buildings, hedges etc.; move to a position where you have an un-interrupted view of the
machine.
Never operate the machine standing directly in the line of travel.
Do not use the machine on sand piles, gravel, or similar materials.
Only operate the machine in good light conditions.
Never run the machine in an enclosed area or building.
Keep the machine clean to avoid build ups of dry materials that could ignite on hot
components.
Never stand directly below a machine that is operating or parked on a slope.
Always operate the joystick control slowly; rapid or jerky movements can cause the machine
to rear up causing loss of control.
When operating the machine with the flail head running the operator must remain at least 5
metres away from the machine; always switch the flail head off before approaching it.
When using the machine the operator should place themselves in a position that provides
optimum visibility over the work area.
Never leave a running machine unattended; always switch the engine off and remove the
ignition key.
Always stop and switch the machine off if persons or animals enter the work area, do not
restart the machine until they are at a safe distance.
Never use the machine to perform tasks it was not designed for.
Never ride, or allow others to ride on the machine.
Always inspect the work area prior to operation and remove stones, glass, metal, wire or any
other foreign objects that are hazardous. Immovable hazards should be ‘marked’ so they
can be avoided.
Take extra care when operating the machine on slopes or uneven ground, there is increased
risk of objects being thrown from the flail head when working in these conditions.
The machine can be used on slopes up to a maximum of 55° (track option dependant)
providing the surface is dry and firm.
To Next Page
