McConnel RoboCut - Electrical System Overview; Fuses, Relays, and Wiring Diagrams

41
X97/R1 Pull Solenoid relay X99/R2 Manual control
X97/R2 Air Heater (optional) X99/R3 Beacon lamp
X97/R3 Starter relay X99/R4 Clean Fix fan
X97/R4 Battery switch X99/R5 Check test before start
X98/R1 Actuator + X99/R6 Engine oil pressure sensor
X98/R2 Actuator - X99/R7 High water engine temperature
X98/R3 Horn
X98/R4 Free
X98/R5 Lower hyd. oil level
X98/R6 Hold solenoid
X98/R7 Free
X99/R1 Radio-Control stop (Link missing)
ELECTRICAL SYSTEM (Machines Serial No. ROBO071300323 onwards)
Fuses & Relays
F1 Fuel Pump 7.5 Amp
F2 Actuator 7.5 Amp
F3 +15 Controllers & Display 5 Amp
F4 Hold Solenoid + Safety Stopdown 10 Amp
F5 Pull Solenoid 30 Amp
F6 +15 Warnings Relay 5 Amp
F7 Beacon 15 Amp
F8 Horn 10 Amp
F9 Wiring Control 15 Amp
F10 +12V Sensors & Buttons 5 Amp
F11 Alternator 5 Amp
F12 Free
F13 +30 3B6 Controller 20 Amp
F14 +12V Plug 10 Amp
F15 Receiver Fuse 7.5 Amp
F16 +20 Canview Display 3 Amp
X95 General Fuse 40 Amp