2. Use the arrow button and the OK button to
move through the menu structure
Settings >
Installation > Starting point
.
3. Use the arrow buttons to specify the
distance in cm.
4. Push the BACK button.
3.10.8 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
factory setting is 32 cm. You can select a
distance of 20-40 cm.
Note: If the
Drive Past Wire
distance is changed,
the distance will change along the boundary wire
in every point of the yard.
3.10.8.1 To set the Drive Past Wire function
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow button and the OK button to
move through the menu structure
Settings >
Installation > Drive Past Wire
.
3. Use the arrow buttons to set the distance in
cm.
4. Push the BACK button.
3.10.9 ECO mode
If
ECO mode
is activated, it switches off the
signal in the boundary loop, the guide wire and
the charging station, when the product is parked
or is charging.
Note:
Use
ECO mode
to save energy and avoid
interference with other equipment, for example
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
3.10.9.1 To set the ECO mode
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Installation > ECO mode
.
3. Push the
OK button to select the
ECO
mode
.
4. Push the BACK button.
3.10.10 To avoid collisions with the mower
house
If you have installed a mower house (available as
accessory), the wear on the product and the
mower house decreases when you select
Avoid
house collisions
.
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Installation > Mower house > Avoid house
collisions
.
3. Push the BACK button.
Note: If
Avoid house collisions
is selected it can
result in grass that is not cut around the charging
station.
3.10.11 Bluetooth
®
The product can connect to mobile devices that
have the McCulloch ROB app installed. It is a
free app for your mobile device. The short-range
interaction with the product is called Bluetooth
®
.
When pairing between the product and app has
been confirmed, you have access to the menus
and functions as long as you are within short-
range (Bluetooth
®
).
3.10.11.1 To pair the McCulloch ROB app and
the product
1. Download the McCulloch ROB app on your
mobile device.
2. Do steps 1–3 in
To get access to the menu
on page 23
.
3. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Installation > Bluetooth > New pairing
.
4. Follow the instructions in the app.
3.10.12 General
In
General
you can change the general settings
of the product.
3.10.12.1 To set the time & date
1. Do steps 1–3 in
To get access to the menu
on page 23
.
28
- Installation
1411 - 001 - 18.12.2019
To Next Page
Loading...
