2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Installation > Lawn Coverage > Area 1
.
3. Use the arrow buttons to select the % of the
cutting time the product must cut the area.
The % is equal to the % of the area in
relation to the complete work area.
a) Measure the area.
b) Divide the area with the work area.
c) Convert the result to %.
4. Push the BACK button.
3.10.6.2 To do a test of the Lawn Coverage
function
1. Put the product in the charging station.
2. Do step 1-3 in
To get access to the menu on
page 23
.
3. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1 > More > Test
.
4. Push the OK button.
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
3.10.6.3 To disable or enable the Lawn Coverage
function
Disable or enable the
Lawn Coverage
function for
each area.
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1 > Disable
.
3. Push the
OK button.
4. Push the BACK button.
3.10.6.4 To reset the Lawn Coverage settings
You can reset the
Lawn Coverage
settings for
each area and use the factory setting.
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1 > More > Reset
.
3. Push the OK button.
3.10.7 Starting point
This function allows you to control how far the
product drives along the guide wire from the
charging station before it starts operating. The
factory setting is 60 cm and the maximum
distance is 300 cm.
Note: The product straddles the guide wire from
the charging station to the starting point. Keep as
short distance to the starting point as possible to
reduce the risk of tracks forming on the lawn.
If the charging station is placed in a limited space
area, for example under a veranda, choosing a
good starting point is important so that the guide
calibration process is optimized. Refer to
Guide
calibration on page 23
.
A) Starting point
B) Minimum distance cm / ft (perpendicular to the
guide wire). If less distance, the calibration
process is interrupted. For the widest possible
guide corridor, have a minimum distance of m / ft.
Refer to
Guide calibration on page 23
.
3.10.7.1 To set the starting point
1. Do steps 1-3 in
To get access to the menu
on page 23
.
1411 - 001 - 18.12.2019
Installation - 27
To Next Page
Loading...
