3 frequency levels: Low, Mid and High. The
higher the frequency, the longer the product is
allowed to work.
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn shield > Cutting time
.
3. Use the arrow buttons to select
Low, Mid
or
High
frequency.
4. Push the BACK button.
3.10.5 Security level
There are 3 security levels for the product.
Function Low Medium High
Alarm X
PIN-code X X
Time lock X X X
• Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
• PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for a
time. The lock is extended for each new
incorrect try.
• Time lock - The product locks if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
3.10.5.1 To set the security level
Select 1 of the security levels for your product.
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Security > Security level
.
3. Use the arrow buttons and the OK button to
select the level of security.
4. Push the
OK button.
3.10.5.2 Security - Advanced
To create a new loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if two
adjacent installations have very similar signals.
1. Place the product in the charging station.
2. Do steps 1–3 in
To get access to the menu
on page 23
.
3. Use the arrow buttons and the OK button to
move through the menu structure
Security >
Advanced > New loop signal
.
4. Await confirmation that the loop signal has
been generated. This normally takes about
10 seconds.
To change the PIN-code
1. Do steps 1–3 in
To get access to the menu
on page 23
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Security > Advanced > Change PIN-code
.
3. Enter the new PIN code.
4. Push the OK button.
5. Enter the new PIN code.
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3
.
3.10.6 Lawn Coverage
The
Lawn Coverage
function is used to guide the
product to remote parts of the work area. If the
work area includes remote parts that are
connected with narrow passages, the
Lawn
Coverage
function maintains a well-cut lawn in all
parts of the yard. You can set the frequency of
how often the product starts to follow the guide
wire to mow in the connection with the boundary
wire. If the
Lawn Coverage
function is not used,
the product starts to mow from the charging
station.
3.10.6.1 To set the Lawn Coverage function
1. Do steps 1–3 in
To get access to the menu
on page 23
.
26
- Installation
1411 - 001 - 18.12.2019
To Next Page
Loading...
