18
Manual No. 4111-0019
May 2015
July 2016
OPERATION
The dock leveler operation instructions are divided
into the two methods of loading and unloading:
• For ramp loading and unloading, see Ramp
Loading/Unloading Instructions on page 19.
• For end loading and unloading, see End Loading/
Unloading Instructions on page 20.
Operating Instructions
Stay clear of dock leveler when transport vehicle
carrier is entering or leaving dock area.
DO NOT move or use the dock leveler if anyone is
under or in front of leveler.
Keep hands and feet clear of pinch points. Avoid
putting any part of your body near moving parts.
Failure to follow these instructions will result in
death or serious injury.
Only trained personnel should operate the dock
leveler.
DO NOT use a broken or damaged dock leveler.
Make sure proper service and maintenance
procedures have been performed on leveler before
using.
Transport vehicle wheels must be chocked unless
the vehicle restraint is used. Never remove the
wheel chocks until loading/unloading is finished
and transport vehicle driver has been given
permission to leave.
Make sure platform lip rests on the transport
vehicle bed with at least 4 in. (102 mm) of overlap.
Maintain a safe distance from side edges of leveler
during the loading/unloading process.
Failure to follow these instructions could result in
death or serious injury.
The MP dock leveler is designed to compensate for
a maximum ± 12 in.* (305 mm) of height difference
between the loading dock and the transport vehicle
bed. DO NOT use the dock leveler if the transport
vehicle bed is more than 12 in. (305 mm) higher or
lower than the dock floor.
*service height may vary with design specifications
DO NOT overload the dock leveler.
DO NOT operate any equipment while under the
influence of alcohol or drugs.
DO NOT leave equipment or material unattended on
the dock leveler.
Failure to follow these instructions could result in
death or serious injury.
12 in. (305 mm)
12 in. (305 mm)
When activating the leveler, always pull swiftly AND
hold the platform release ring until the platform is at
the full raised position. Releasing the ring while the
platform is still raising may result in damage to the
equipment
To Next Page
Loading...