4
Manual No. 4111-0019
May 2015
July 2016
SAFETY
A maintenance prop permanently attached and
hinged to the unit with means for lock out/tag out
requirements (per OSHA 1910.147) is included with
each pit style dock leveler. In addition, it is recom-
mended and good safety practice to use an addi-
tional means to support the dock platform and lip
anytime when physically working in front of or under
the dock leveler. This additional means may include,
but not limited to a boom truck, fork truck, stabilizing
bar or equivalent. Failure to follow these instructions
will result in death or serious injury.
Maintenance Safety Precautions
Electrical power must be OFF when servicing the
equipment. For maximum protection, use an OSHA
approved locking device to lock out all power
sources. Only the person servicing the equipment
should have the key to unlock the device.
Failure to follow these instructions will result in
death or serious injury.
1.50"
3.00"
Decal Size: 1.5 x 3
File Name: 1751-0736 Rev A
Arc Flash and
Shock Hazard
PPE [Personal Protection
Equipment] Required
De-energize equipment before
working on or inside. Do not
open cover without appropriate
PPE. Refer to NFPA 70E for
PPE requirements. This panel
may contain more than one
power source.
Hazardous Voltage
Will Result in Death
or Serious Injury
1751-0736 Rev A
ALWAYS disconnect electrical power source and
ground wire before welding on dock leveler.
DO NOT ground welding equipment to any hydraulic
or electrical components of the dock leveler. Always
ground to the dock leveler frame.
Failure to follow these instructions could result in
death or serious injury.
ALWAYS stand clear of dock leveler lip when
working in front of the dock leveler.
Failure to follow these instructions could result in
death or serious injury.
DO NOT grind or weld if hydraulic fluid or other
flammable liquid is present on the surface to be
ground or welded
DO NOT grind or weld if uncontained hydraulic fluid
or other flammable liquid is present. Stray sparks
can ignite spills or leaks near the work area. Always
clean up the oil leaks and spills before proceeding
with grinding or welding.
Always keep a fire extinguisher of the proper type
nearby when grinding or welding.
Failure to follow these instructions could result in
death or serious injury.
Always post safety warnings and barricade
the work area at dock level and ground level
to prevent unauthorized use of the unit before
maintenance is complete. Failure to follow these
instructions could result in death or serious injury.
To Next Page
Loading...