McIntosh MC3500 User Manual

15
MC3500 PACK ART B
Packing Instructions
In the event it is necessary to repack the equipment
for shipment, the equipment must be packed exactly
as shown below. It is very important that the four feet
are attached to the bottom of the equipment. This will
ensure the proper equipment location on the bottom
foam pad. Failure to do this will result in shipping
damage.
To protect the tubes during shipment, the Foam Insert
removed from the MC3500 needs to be re-inserted.
Follow the unpacking instructions on pages 4-5 in the
reverse order.
Use the original shipping carton and interior parts
only if they are all in good serviceable condition.
If a shipping carton or any of the interior part(s)
are needed, please call or write Customer Service
Department of McIntosh Laboratory, refer to page 2.
Please see the Part List for the correct part numbers.
Quantity Part Number Description
1 034105 Shipping Carton Top
1 034104 Shipping Carton Bottom
1 034680 Tube Foam Insert
2 034679 Pad Top/Bottom
3 034678 Foam Ring
1 241109 Warning Sheet
1 033739 Poly Bag
WARNING SHEET
& TUBE FOAM

McIntosh MC3500 Specifications

General

Input Sensitivity	0.5V
Signal to Noise Ratio	105dB
Input Impedance	100k ohms
Power Output	350 Watts
Frequency Response	20Hz to 20kHz
Total Harmonic Distortion	0.5%
Dimensions	Width 17-1/2 inches (44.5 cm) Height 10-1/2 inches (26.7 cm) Depth 20 inches (50.8 cm) including connectors
Output Impedance	4, 8, 16 ohms