Need help?Do you have a question about the McIntosh MHA150 and is the answer not in the manual?
General| Power Output | 50 Watts |
|---|---|
| Total Harmonic Distortion | 0.005% |
| Input Impedance | 20 kOhms |
| Output Autoformer | Yes |
| Frequency Response | 20Hz - 20kHz |
| Headphone Impedance | 20 - 600 Ohms |
| Digital Inputs | 1 x USB, 1 x Coaxial, 1 x Optical |
| Headphone Output | 1/4" Headphone Jack |
| Type | Headphone Amplifier |
| Frequency Response (Headphone) | 20Hz - 20kHz |
| Signal to Noise Ratio | 100dB |
| Inputs | USB, Optical, Coaxial, RCA |
| Outputs | 1 Headphone |
Connecting to computers via USB and installing necessary software drivers.
How to enter and navigate the MHA150's setup menu.
Creating, renaming, and deleting custom headphone profiles.
Powering on/off, source selection, and volume control.
Using trim levels, balance, bass boost, and mono/stereo modes.
Connecting headphones, HXD®, and output control for listening devices.
To Next Page
