MS300 Advanced Users Guide
3/3/2005
Page 12 of 65
2 Chambers Street • Binghamton, NY 13903-269 Phone: 607-723-3512 / 800-538-6576 • Fax: 607-724-0549
Technical Support 866-458-6910 9:00AM to 6:00PM EST, M-F www.mcintoshlabs.com
• Set each changer to address Command Mode 1.
Kenwood DVD/CD Changer Hookup
• Up to three Kenwood DV-5900 or DV-5050 400 disc changers may be connected
via individual RS232 cables (do not daisy chain)
• Connect a 1/8" mono or stereo mini connector from the DVD Control jack on
each changer to the corresponding S-Link/IR Input jack on the back of the MS300
• An RS-232 cable is a standard DB9 null modem cable (not included with the
changer)
• All audio outputs from changers should be connected to the MS300 (do not daisy
chain)
• The analog audio connection is required when recording from external changers
• Set each changer to address MAIN.
• Only CDs in Kenwood changer will appear in the MS300 Music Guide.
Pioneer DVD/CD Changer Hookup
Note: The Pioneer FV-07 is ONLY supported for CDs with the MS300 Music Server.
The Pioneer FV-07 can not be used for Movie storage.
• Up to three Pioneer DV-F07 300 disc changers connected via individual custom
RS232 cables.
• The RS-232 cables are DB9 to DB15.
• All audio outputs from changers should be connected to the MS300 (do not daisy
chain)
• The analog audio connection is required when recording from external changers
• Only CDs in Pioneer changer will appear in the MS300’s Music Guide
Pin-out for the MS300 RS-232 DB-9 to DB-15 control cable
DB-9 Female (MS300 side) DB-15 Male (Pioneer Side)
Pin 5 Ground Pin 1 Ground
Pin 2 RD Pin 2 TD
Pin 3 TD Pin 3 RD
To Next Page
Loading...
