MS300 Advanced Users Guide
3/3/2005
Page 32 of 65
2 Chambers Street • Binghamton, NY 13903-269 Phone: 607-723-3512 / 800-538-6576 • Fax: 607-724-0549
Technical Support 866-458-6910 9:00AM to 6:00PM EST, M-F www.mcintoshlabs.com
Changing the Volume Lock
The remote is preset to control volume through your TV while in the TV, CBL, and DVD
modes. However, in an Audio mode (i.e. RCV, MS1, MS2, MS3, MS4), you have
separate control of your audio component’s volume.
Follow these steps to control the volume of the component instead of the TV.
1. Press and hold CODE SET until the LED blinks twice, then release CODE SET.
2. Enter 9 - 9 - 3 and then press any mode key once (except TV). The LED will
blink twice.
3. Now, whenever you press VOL +, VOL –, or MUTE, the volume will be
controlled by the current mode.
Follow these steps to control the volume of the TV when in other modes (factory default).
1. Press and hold CODE SET until the LED blinks twice, then release CODE SET.
2. Enter 9 - 9 - 3 and then press TV. The LED will blink twice.
3. Now, whenever you press VOL +, VOL –, or MUTE on the Remote, volume will
be controlled by your TV.
Resetting the MS Source Buttons
The MS1, MS2, MS3, and MS4 source buttons are preprogrammed at the factory with the
correct codes to control four MS300 Music Servers. If you changed these buttons to
control other devices, you will have to reset the MS Source buttons back to the original
codes in order to control the MS300 again.
Follow these steps to program the buttons back to their factory states:
1. Press the MS1, MS2, MS3, or MS4 source button to be re-programmed.
2. Press & Hold the “Code Set” button on the remote until the LED flashes twice.
3. Enter “987” using the remote’s numeric keypad. The LED should again flash
twice.
4. Enter the factory reset code which corresponds to the MS button being reset:
o “0082” for MS1
o “0083” for MS2
o “0084” for MS3
o “0085” for MS4
5. The LED will again flash twice indicating the programming was successful.
Repeat these steps for each MS300 in your system, selecting a different MS button for
each.
To Next Page
Loading...
