McIntosh MX121

19
9. With "Store" highlighted again, press the ENTER
Push-button. Saving the results requires about 10
seconds. Refer to the illustration below:
10. Referring to the illustration below with "No" high-
lighted, press the ENTER Push-button. For more
information about Audyssey Dynamic Volume
®
together with other Audyssey Operational Func-
tions refer to page 37 in the "How to Operate"
section of this Owner's Manual.
Note: Audyssey Auto Setup procedure will need to be
performed again, when changes are made to the
number of Loudspeakers, their replacement in
the room or changes to the Subwoofer(s) Opera-
tional Controls.
Refer to the illustration below:
8. With "Next Store" highlighted press the ENTER
Push-button. Refer to the illustration below:
Note: If the measuring results are not to be saved,
press the RETURN Push-button and a message
“Cancel Auto Setup?” will be displayed. Press
 ,then select “Yes”. All the measured Audyssey
Auto Setup data will be erased.
[5/6]
STEP5 Check
Check processing res-
ults. To proceed,press
“Next”
Select item to check
Spkr Config Check
Distance Check
Ch. Level Check
Crossover Check
Next Store
AUTO SETUP
AUDYSSEY AUTO SETUP
ENTER Enter RETURN Cancel
MultEQ XT
[6/6]
STEP6 Store
Press “Store” to store
calculation results.
Apply and store measurement result
Store
AUTO SETUP
AUDYSSEY AUTO SETUP
ENTER Enter RETURN Cancel
MultEQ XT
[6/6]
AUTO SETUP
AUDYSSEY AUTO SETUP
STEP6 Store
Now storing...
Please wait.
25%
MultEQ XT
[6/6]
Finish
Storing complete.
Auto Setup is now
finished. Please unplug
microphone.
Turn on Dynamic Volume?
AUTO SETUP
AUDYSSEY AUTO SETUP
ENTER Exit
Turn Dynamic Volume on and exit Auto Setup
Yes No
MultEQ XT
Setup Mode, con't
Audyssey
®
Parameter Check
Once the Setup Process has been completed, the
Parameter Check Function becomes available. From
the On-Screen Main menu first select "Auto Setup"
followed by "Parameter Check". Refer to the illustra-
tion below:
1. Using the Remote Control Directional Push-but-
tons, select the desired Parameter and follow the
On-Screen Instructions.
Speaker Config Check
Distance Check
Channel Level Check
Crossover Check
EQ Check
Restore
AUTO SETUP
PARAMETER CHECK
Show speaker configuration result