www.marketdirect.com.au
Ph: 1300 494 494
©Copyright
12 MONTHS / 10,000KM SERVICE
CHECKED
•
Inspect for damage and lubricate. Check bolt Torque to 90Nm
• Inspect for condition and operation
Breakaway
• Check for correct operation.
• Inspect lanyard and clip
• Inspect wiring grommets and general condition
Suspension
• Grease bushes and check for play.
• Check torque on suspension hanger bolts (190nm)
• Check retaining chain shackles tight.
• Inspect shock absorber for condition.
• Inspect shock absorber bushes
• Inspect and adjust. Check lining thickness and drum wear
Wheel bearings
• Replace bearings, seals and lubricate. Check stub axle condition
and wear. Replace split pin.
Wheel Nuts
• Inspect condition and torque to 125Nm (12mm studs)
(140Nm 14mm studs alloy rims) (200Nm 14mm studs steel rims)
Tyres
• Inspect for abnormal wear, damage, and pressure.
• Check manufacturing date less than 5 years.
• Check sidewalls for perishing and damage.
Lights
• Check all trailer lights are functioning.
• Check plug pins have gap.
Battery
• Check terminals and voltage at full charge.
• Check batteries are secure in cradles
Charging
• Check battery charger settings are correct.
• Check DC to DC charger settings are correct
Solar Panels
• Check panels are free of damage.
• Inspect sealants on cable penetrations and junction boxes
Cables
• Inspect cables under body for damage to conduits.
• Inspect cable glands and sealants on penetrations through floor
•
Check operation of RCD via test button
• Inspect mains input plug and cover are free of damage
•
Carry out resistance check
• Check and lubricate locks
Seals
• Check condition and correct latch/lock adjustment for correct 30-
50% compression
Body
• Inspect joint sealants inside and out.
• Ensuite joints checked for damage and adhesion.
• Inspect for soft spots on floor
•
Check all structural fixing are secure.
To Next Page
Loading...
