Mec Micro 26 - Page 46

Page 42 Micro 26 - Service & Parts Manual
April 2019Section 15 - Parameter Adjustments
Low Speed Drive
This parameter controls low speed drive when the platform is in the stowed position and Low Speed
is selected (turtle icon).
ART_5131
Press the Drive Mode Select button. The button will light up,
indicating this mode is active.
Press and hold the Low Speed Mode Select button (turtle
icon). The button will light up, and the LED Indicator will show
the present setting.
Adjust the speed using the steer left and steer right buttons
on top of the Control Handle.
Low Drive Speed can be set from 00 to 9°9, but must not be
set higher than 50. Factory setting is 50.
DO NOT ADJUST THE SETTING HIGHER
THAN 50.
Save the new setting (see “Saving New Values” on page 40).
1.
2.
3.
4.
5.
Elevated Drive Speed
This parameter controls drive speed when the platform is elevated.
ART_5132
Press the Drive Mode Select button. The button will light up,
indicating this mode is active.
Press and hold the Low Speed Mode Select button (turtle
icon). The button will light up, indicating this mode is active.
Adjust the speed using the steer left and steer right buttons
on top of the Control Handle.
Elevated Drive Speed can be set from 00 to 9°9, but must not
be set higher than 50. Factory setting is 50.
DO NOT ADJUST THE SETTING HIGHER
THAN 50.
Save the new setting (see “Saving New Values” on page 40).
1.
2.
3.
4.
5.