Mec Micro 26 - Page 23

Page 19 Micro 26 - Operator’s Manual
March 2019Section 7 - Operating Instructions and Function Tests
To Drive
ART_5022
Function
Enable
Control Handle
Press the drive function select button.
Press and hold the Function Enable Switch on the control handle.
Increase speed: Slowly move the control handle off center.
Push the control handle forward to move forward. Pull the control
handle rearward to move rearward.
Decrease speed: Slowly move the control handle toward center.
Stop: Return the control handle to center or release the Function
Enable Switch.
Regardless of if the Function Enable Switch is pressed or released, if no
machine movement is made in 10 seconds then the current selection of Drive
will time-out.
Release then press the Function Enable Switch to reactivate selected function.
Use the color-coded direction arrows on the platform controls to identify the
direction the machine will travel.
Machine travel speed is restricted when the platform is raised.
Battery condition will affect machine performance. Machine drive speed and
function speed will drop when the battery level indicator is flashing.
1.
2.
3.
•
•
•
To Reduce Drive Speed
ART_5023
The drive controls can operate in two different drive speed modes.
When the drive speed button light is on, slow drive speed mode is active.
When the button light is off, fast drive speed mode is active.
Press the drive speed button to select the desired drive speed.
Driving On A Slope - Stowed Position Only
Determine the slope and side slope ratings for the machine and determine the slope grade.
Maximum forward/rearward slope rating, stowed position 14° (25%).
Maximum side slope rating, stowed position 5° (9%).
Note:Slope rating is subject to ground conditions and adequate traction.
Press the drive speed button to the slow drive speed mode.