Setup
This section contains information about setting up your instrument and preparing to play. Please go through this section carefully
before turning the power on.
1. Move the MASTER VOLUME slider downwards to set the minimum
volume level.
2. Connect the AC/DC adaptor to the power supply jack.
3. Plug the AC/DC adaptor into an AC outlet.
4. Turn the power ON. The LCD on the panel will light up.
Note:
When the keyboard is not in use or in the time of thunderstorm, please
disconnect the power for safety purpose.
Power Supply
Setting a Music Stand
The instrument is supplied with a music stand that can be attached to
the instrument by inserting it into the slot at the rear of the panel.
Connecting a Footswitch
The sustain function lets you produce a natural sustain as you play by
pressing a footswitch. Plug an optional footswitch into this jack and use
it to switch sustain on or off.
Connecting a Volume Pedal
An optional volume control can be plugged into the volume jack for
adjusting the volume of sound.
7
1
2
1
2
To Next Page
Loading...
Need help?
General
