MEGA65 Welcome Guide
If your HDMI display supports audio, enable “Enhanced (with audio)” mode in the MEGA65 configuration. Otherwise
set it to “DVI only (no audio).”
Note: As of this writing, the Hypervisor utility menu, Configuration, SD card utility, and core selection screens use
“Enhanced (with audio)” mode by default. This fails on older DVI displays that don’t know how to handle this signal.
You may need to use a modern HDMI display or a VGA display to access these screens. See core issue 552.
Tip: Be sure to try “CRT emulation” mode in the MEGA65 configuration with a flat panel display to see if you like
it.
82 Chapter 13. Video display compatibility
To Next Page
Loading...