"
2;$$%-?;<&2;$$%-?;<)"! "3$&$
Thermal printer mechanism HSP2208-KSR-GB
(optimized for 12V and high humidity)
HSP2208-KSR
(optimized for 24 V and thicker paper)
Supply voltage 10.8 – 26.5 VDC
Print procedure thermal sensitive
Number of dots 448 dots/line
Resolution horizontal / vertical 203 dpi (8 dot/mm)
max. print width 56 mm
max. paper width 60.5 mm
Print speed max. 250 mm/s @24 VDC
max. 70 mm/s @12 VDC
Presenter speed max. 500 mm/s @24 VDC
max. 400 mm/s @12 VDC
Traction power 2.35 – 7.00 N ±20%
24 V 50 mm/s 900 g 7.00 N (not -GB) →
24 V 100 mm/s 750 g 5.90 N→
24 V 150 mm/s 600 g 4.70 N→
24 V 200 mm/s 450 g 3.50 N→
24 V 250 mm/s 300 g 2.35 N→
12 V 50 mm/s 750 g 5.90 N→
12 V 100 mm/s 600 g 4.70 N→
presenter motor / current =46% 500 mm/s approx. 2 N
MTTF printer 100 km paper length
50 million pulse
MTTF cutter vs. MTBF 2 million cuts
(only under standard ambient conditions)
The cutter life time depends on the printer paper used. Pre-printed paper or a
diffraction foil reduce the cutter life time. This has to be tested separately with
standard paper JUJO AF50KS-E at 24 VDC / 20 – 25°C / head temperature max. 40°C
/ nominal energy ratings. The life time according to the APS printing unit test
conditions is only achieved with the specied paper. The printhead and cutter life
cycle is an average expected performance and is not a guaranteed data. Under
optimal conditions, the above data can be obtained using the specied paper.
Cutting time approx. 0.5 seconds @ 80 µm @ 24 VDC 0 – 50°C°
$()#(+,-
#(./
Cutter knife Steel 1.4034 + black coating
Sound level approx. 62 dBA peak
GPT-4672-PM lying isolated on textile, measurement in a distance of 1 meter with
sound level meter SL-100
-(#!
("(" ) " *+,-+,-+..% !"",'$/.,%.%%.
0"(! "(12 3 *+,-+,-+..'' .+4$%$.
5".6 )7 .68..$
-$..%"7 "3971," 7"31"1)),
" ,71," "! "75,
To Next Page
Loading...