"
.+ ;;>
.+,. ::L
The printer can either be screwed tightly to the bezel with 4 screws or clipped on using two quick-release fasteners, see
gure 58.
Two optional side clips lock the printer when it is clipped on in the event of shock or vibration.
076-
If the bezel is correctly fastened with screws, a paper roll up to 150 mm in diameter is permitted on the standard paper roll
holder. However, this only applies if no shocks or vibrations occur. Otherwise, we recommend adding additional support to
the printer.
If the bezel is glued, a paper roll holder on the printer is not permitted.
("(" ) " *+,-+,-+..% !"",'$/.,%.%%.
0"(! "(12 3 *+,-+,-+..'' .+4$%$.
5".6 )7 6-8..$
-$..%"7 "3971," 7"31"1)),
" ,71," "! "75,
To Next Page
Loading...