26
Repair and Warranty
The instrument contains static sensitive devices, and care must be taken in handling the printed circuit board. If an instrument’s protection
has been impaired it should not be used, but sent for repair by suitably trained and qualified personnel. The protection is likely to be
impaired if for example, it shows visible damage, fails to perform the intended measurements, has been subjected to prolonged storage
under unfavourable conditions, or has been subjected to severe transport stresses.
FOR INSTRUMENT WARRANTY DETAILS PLEASE REFER TO WARRANTY CARD SUPPLIED WITH INSTRUMENT.
Note: Any unauthorized prior repair or adjustment will automatically invalidate the Warranty.
CALIBRATION, REPAIR AND SPARE PARTS
For service requirements for Megger Instruments contact:
Megger Limited
Archcliffe Road
Dover
Kent CT17 9EN
England.
Tel: +44 (0) 1304 502 243
Fax: +44 (0) 1304 207 342
Megger operate fully traceable calibration and repair facilities, ensuring your instrument continues to provide the high standard of
performance and workmanship you expect. These facilities are complemented by a worldwide network of approved repair and calibration
companies to offer excellent in-service care for your Megger products.
To Next Page
Loading...
Need help?
General
