3
G SAFETY WARNINGS
Safety warnings and precautions must be read and understood before the instrument is used. All Safety warnings and
precautions must be observed during use.
The circuit under test must be switched off, de-energised, securely isolated and proved safe before test connections are
made.
Use the correct lead set. On power systems the Megger fused lead set must be used. Refer to the Test Lead selection page in
this user guide to identify the correct lead set.
The operator must verify that the circuit is safe before testing and take the appropriate precautions.
Ensure that hands remain behind guards of probes/clips when testing.
The instrument should not be used if any part of it is damaged. Also all test leads, probes and crocodile clips must be in good
order, clean and with no broken or cracked insulation.
Disconnect the test leads before removing the battery cover. The battery cover must be in place whilst conducting tests.
This product contains no user service parts.
All relevant safety procedures must be followed.
THE INSTRUMENT MUST ONLY BE USED BY SUITABLY
TRAINED AND COMPETENT PERSONS
To Next Page
Loading...
Need help?
General
