Melitta c5 - Checking the Desired Milk Temperature; Programming the Desired Milk Temperature

OPERATION
OI c5 eng V9 / 18.08.2006 5 - 3 © Cafina / Melitta
E
5.1.4.4 Checking the desired milk
temperature
1. Press ENTER for approx. 2 seconds ...
- On the display, the word "SET" will
appear.
2. Press ENTER a second time, but this
time only briefly ...
- The digit light spot "Setting mode"
will flash for approx. 12 seconds.
- On the display, the desired milk tem-
perature will appear.
3. Press ENTER for approx. 2 seconds or
wait until the digit light spot "Setting
mode" stops flashing.
5.1.4.5 Programming the desired
milk temperature
1. Press ENTER for approx. 2 seconds ...
- On the display, the word "SET" will
appear.
2. Press ENTER a second time, but this
time only briefly ...
- The digit light spot "Setting mode"
will flash for approx. 12 seconds.
- On the display, the current desired
milk temperature will appear.
- To set the desired milk temperature,
press the UP / DOWN buttons as re-
quired.
3. Press ENTER for approx. 2 seconds or
wait until the digit light spot "Setting
mode" stops flashing.
- The desired milk temperature is now
set, and the approximate actual milk
temperature is indicated on the dis-
play.
NOTE
• Alternative settings for the
desired milk temperature
will be found in the separate
specification for the temper-
ature regulator unit.
NOTE
• Factory setting: 5 °C
• Adjustment range:
between 3 °C and 6 °C