Melitta Caffeo Solo User Manual

6262
9.3 Integrated cleaning programme
The integrated cleaning programme removes residues, including coffee oil residues,
that cannot be eliminated by hand. It takes a total of approximately 15 minutes. The
cleaning symbol ashes during the entire process.
Prerequisite: The appliance must be switched off (see „Switching on and off“
on page 49).
Caution!
– Run the integrated cleaning programme every 2 months or after
approximately 200 brewed cups of coffee; at the latest, however, run the
programme when the symbol for cleaning lights up on the display.
– Only use Melitta
®
cleaning tabs for fully automatic coffee makers. These
cleaning tabs are specically designed for the Melitta
®
CAFFEO
®
SOLO
®
.
The use of other cleaning agents can damage the appliance.
Run the integrated cleaning programme as follows:
1 Open up the ap of the water tank (Fig. A, no. 6) and pull the water tank
up and out of the appliance. Fill the water tank to the max. mark with
fresh tap water and reinsert it.
2 Simultaneously press both the button for one-cup dispensing and
the ON/OFF button for about 3 seconds.
→ The symbol for cleaning ashes.
The drip tray symbol illuminates.
3 Empty the drip tray and coffee grounds container.
4 Reinsert the drip tray without the coffee grounds container and place
the coffee grounds container under the outlet.
Phase 1
During Phase 1, the one bean symbol is shown on the display.
→ First, two automatic rinsing processes are carried out. The standby symbol
will then be illuminated.
5 Reach into the recess on the right side of the appliance (Fig. A, no. 11)
and pull off the cover to the right.

Melitta Caffeo Solo Specifications

General

Product type	Espresso machine
Self-cleaning	Yes
Capacity in cups	2 cups
Coffee input type	Coffee beans
Appliance placement	Built-in
Type	Coffee/Espresso
Product color	Black
Built-in display	No

Weight and Dimensions

Depth	455 mm
Width	200 mm
Height	325 mm